This quick guide will teach you how to add the Mega.nz Repositroy so you can easily install and upgrade the “Megacmd” and “Megasync” apps on your Linux Distribution. This tutorial will show you how to do it specifically on Ubuntu 20.04, however, the instructions can be easily modified for any ARM based debian based distribution.
Go to the Mega.nz repository at https://mega.nz/linux/repo/ in your web browser, and select the folder that pertains to your working distribution. For the Raspberry Pi (because you need the ARM version), that is going to be the Raspbian_10.0 folder located at https://mega.nz/linux/repo//.
Then Go to your terminal and add the Release.key file to your apt repository:
wget https://mega.nz/linux/repo/Raspbian_10.0/Release.key && sudo apt-key add Release.key
STEP 2: Figure out your systems architecture.
Before adding mega.nz to your repository list, you first need to verfiy that you are using the 32-bit Ubuntu or Raspberry Pi OS distribution. If you are not, then you need to add the 32 bit architecture to your OS.
Verify your architecture with the following command:
If the above command returns “arm64”, then proceed to the next step (STEP 2b). If the above command returns “armhf”, then you shoudl skip the next step (STEP 2b). If it returns “arm64” then you should continue with the next step (STEP 2b).
Add support for a 32-bit arm foreign architecture (armhf) with the following command:
sudo dpkg --add-architecture armhf
Verify you are now using armhf as a foreign architecture, with the following command:
You should see “armhf” from this command. Now you may move on to STEP 3.
Add the mega.nz repo to your apt repository by openining up your nano editor in terminal…
sudo nano /etc/apt/sources.list.d/mega.nz.list
then pasting the indicated code below:
# Source Repository for Mega-CMD and Mega Desktop (For Raspbian ARM) # Updated Mega Repo with 4092 bit Release Key deb [arch=armhf] https://mega.nz/linux/repo/Raspbian_10.0/ ./
Type “Control-X“, then “y“, then “Enter“, to save and quit your nano editor.
Now, update your apt list, then install mega-cmd from your newly added repository with the following command:
sudo apt update && sudo apt install megacmd
Now, whenever you run the command
sudo apt update && sudo apt upgrade your “megacmd” installation will automatically update, when updates are available.
To run your newly installed mega command line application run the following command:
2 thoughts on “How to install and update Mega command line (megacmd) on your Raspberry Pi running Ubuntu 20.04”
Thanks a lot! it worked!!!
You are most welcome @GABBOZ5. I’m glad someone found this of use!